Georjulia - how to avoid holes?
#1
Hello Garth, I've tried to repeat your explanation and have used two tori symmetrical but without success (f.e. x,y,z-axis + and -50 aso.). Please could you explain what you mean with "use two tori separated enough to avoid the repelling zones"? Thank you and regards
Kaspar


Attached Files Thumbnail(s)
   

.xep   Untitled.xep (Size: 2.71 KB / Downloads: 2)
Reply
#2
When the torus creates these crosses with holes in the middle it usually means you can move the torus in the direction it's facing, which is Z in this case, and see the cross divide into two curves that miss the center. But the result is not as symmetric. So if you moved the torus say 5 units to get clear of the center, just clone it and move the clone back to be 5 units the other way from where it started (this is easiest if it was at 0 to begin with). (For anyone trying this example, the torus is hidden so it helps to unhide it before adjusting positions.) Here's the example:

.xep   Untitled-2.xep (Size: 3.07 KB / Downloads: 5)

And here is Georjulia
   

.xep   Georjulia.xep (Size: 5.57 KB / Downloads: 6)
Reply
#3
Super, thank you so much for this amazing idea!!

Regards Kaspar
Reply


Forum Jump: